How do I set up Port Forwarding on my Fibre router ?

In order to set up Port forwarding, you need to log in to the Fibre router itself. For more help on logging into the Fibre router see here.

Once you have logged in, follow these steps:

Click Network Setting > NAT > Port Forwarding to open the following screen

Click Add New Rule in the Port Forwarding screen.

Specify either a port or a range of ports, a server IP address, and a protocol to configure a port forwarding rule.
Please note:

• To configure port forwarding, you need to have the same configurations in the Start Port, End Port, Translation Start Port, and Translation End Port fields.
• To configure port translation, you need to have different configurations in the Start Port, End Port, Translation Start Port, and Translation End Port fields.
• TCP port 7547 is reserved for system use.

Service Name - Enter a name to identify this rule using keyboard characters (A-Z, a-z, 1-2 and so on).
WAN Interface - Select the WAN interface through which the service is forwarded. You must have already configured a WAN connection with NAT enabled.
Start Port - Enter the original destination port for the packets.

• To forward only one port, enter the port number again in the End Port field.
• To forward a series of ports, enter the start port number here and the end port number in the End

End Port - Enter the last port of the original destination port range.
To forward only one port, enter the port number in the Start Port field above and then enter it again in this field. To forward a series of ports, enter the last port number in a series that begins with the port number in the Start Port field above.
Translation Start Port - This shows the port number to which you want the Zyxel Device to translate the incoming port.
For a range of ports, enter the first number of the range to which you want the incoming ports translated.
Translation End Port - This shows the last port of the translated port range.
Server IP Address - Enter the inside IP address of the virtual server here.
Configure Originating IP - Select Enable to enter the source IP address of WAN interface.
Originating IP - Enter the source IP address of WAN interface.
Protocol - Select the protocol supported by this virtual server. Choices are TCP, UDP, or TCP/UDP.
Cancel - Click Cancel to exit this screen without saving any changes.
OK - Click OK to save your changes.

If you have a Fixed Wireless router, you can find instructions on how to set up Port Forwarding here